New Part On a New Aircraft

New Part On a New Aircraft:

Within the Aircraft Parts module, the system provides functionality to install (add) a component to the aircraft configuration, ensuring full traceability and alignment with maintenance and airworthiness requirements.

When initiating the action to add a part, a modal dialog titled “Part into aircraft” is displayed. This dialog defines two distinct workflows for associating a component with the aircraft:

1. From Store (Inventory-based installation)

This option allows the user to select an existing part record from the inventory (store) and assign it to the aircraft. Technically, this implies:

• The part already exists as a serialized or batch-controlled inventory item within the system.
• All relevant metadata (e.g., Part Number, Serial Number, Manufacturer, configuration attributes) is already defined.
• The system maintains traceability, including stock location, previous installations (if applicable), and lifecycle status.
• Upon installation, the component is linked to the aircraft configuration, and its status transitions from in stock to installed.
• Any associated maintenance rules, life limits, or inspection programs are automatically inherited and activated for that aircraft.

This workflow is typically used for controlled components that are managed through logistics, repair cycles, or rotational pools.

2. New (Direct creation and installation)

This option enables the user to create a completely new part record at the moment of installation, without relying on pre-existing inventory data. In this case:

• The user must manually define all required attributes, such as:
  • Part Number
  • Serial Number (if applicable)
  • Manufacturer
  • ATA Chapter classification
  • Configuration or positional data
• The part is immediately instantiated and bound to the aircraft as an installed component.
• This approach is useful for:
  • Components not previously registered in the system
  • Non-serialized parts or ad-hoc entries
  • Initial aircraft configuration setups or data migration scenarios

3. Additional considerations

• Once installed, the part becomes part of the aircraft configuration baseline, contributing to its technical status.
• The system may trigger or associate continuing airworthiness requirements, such as:
  • Life limits (e.g., hours, cycles, calendar time).
  • Scheduled inspections.
  • Airworthiness directives or service bulletins.
• Installation events are typically timestamped and may be audited for regulatory compliance.

- In summary, the interface supports both inventory-driven installation (controlled, traceable parts) and on-the-fly creation (flexible, manual entry), allowing the system to accommodate a wide range of operational and maintenance scenarios.

Also you can see the related rules of the specific part.